| General specifications |
| Sensing range | 200 ... 4000 mm |
| Adjustment range | 240 ... 4000 mm |
| Dead band | 0 ... 200 mm |
| Standard target plate | 100 mm x 100 mm |
| Transducer frequency | approx. 85 kHz |
| Response delay | minimum : 110 ms
factory setting: 615 ms |
| Indicators/operating means |
| LED green | Operating display |
| LED yellow | object in evaluation range |
| LED red | error |
| Electrical specifications |
| Operating voltage | 10 ... 30 V DC , ripple 10 %SS |
| No-load supply current | &le, 50 mA |
| Interface |
| Interface type | Serial interface (programming adapter required)
9600 BPS, no parity, 8 data bits, 1 stop bit |
| Input/Output |
| Input/output type | 1 synchronization connection, bidirectional |
| 0 Level | 0 ... 1 V |
| 1 Level | 4 V ... UB |
| Input impedance | > 12 k&Omega, |
| Output rated operating current | < 12 mA |
| Pulse length | 0.5 ... 300 ms (level 1) |
| Pulse interval | &ge, 62.5 ms (level 0) |
| Synchronization frequency | |
| Common mode operation | &le, 16 Hz |
| Multiplex operation | &le, 17 Hz / n , n = number of sensors , n &le, 10
(factory setting: n = 5 ) |
| Input |
| Input type | 1 program input |
| Level (evaluation limit 1) | 0 ... 1 V |
| Level (evaluation limit 2) | 4 V ... UB |
| Input impedance | > 12 k&Omega, |
| Pulse length | 2 ... 10 s |
| Output |
| Output type | 1 analog output 4 ... 20 mA |
| Resolution | Evaluation range [mm]/3200, however &ge, 0.4 mm |
| Deviation of the characteristic curve | &le, 0.2 % of full-scale value |
| Repeat accuracy | &le, 0.1 % of full-scale value |
| Load impedance | &le, 500 &Omega, at UB &ge, 14V
&le, 300 &Omega, at UB < 14V |
| Temperature influence | &le, 1.5 % of full-scale value |
| Compliance with standards and directives |
| Standard conformity | |
| Standards | EN 60947-5-2:2007+A1:2012
IEC 60947-5-2:2007 + A1:2012
EN 60947-5-7:2003
IEC 60947-5-7:2003 |
| Approvals and certificates |
| UL approval | cULus Listed, General Purpose |
| CCC approval | CCC approval / marking not required for products rated &le,36 V |
| Ambient conditions |
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
| Mechanical specifications |
| Connection type | Connector plug M12 x 1 , 5-pin |
| Degree of protection | IP67 |
| Material | |
| Housing | PA-GF35 |
| Transducer | epoxy resin/hollow glass sphere mixture, polyurethane foam |
| Mass | 120 g |
| Factory settings |
| Output | evaluation limit A1: 240 mm
evaluation limit A2: 4000 mm
output function: rising ramp |
| Beam width | wide |
| Evaluation procedure | low-pass behavior |
| General information |
| Supplementary information | Switch settings of the external programming adapter:
output load: pull-down
output logic: noninv |
