Wenglor C50C101

• MultiCore technology
• Reading of printed and directly marked 1D and 2D codes

The scanner weQubeDecode is based on the wenglor MultiCore technology. Omnidirectional scanning enables decoding of printed, needle-punched, laser-engraved or etched codes on various materials in any orientation. Good scanning results are even obtained with poor code quality. In addition to the established 1D codes it is also suitable for scanning various 2D codes. A list of readable code types is found in the operating instructions.

Working Range	? 20 mm
Resolution	736 ? 480 Pixel
Image Chip	monochrome
Light Source	Infrared Light
Service Life (T = +25 °C)	100000 h
Visual Field	see Table 1
min. Resolution	0,1 mm
Barcode Printing Contrast	> 15 %

Electrical Data

Supply Voltage	18...30 V DC
Current Consumption (Ub = 24 V)	< 200 mA
Scan Rate	20 scans/sec
Temperature Range	-25...55 °C*
Inputs/Outputs	6
Switching Output Voltage Drop	< 2,5 V
Switching Output/Switching Current	100 mA
Short Circuit Protection	yes
Reverse Polarity Protection	yes
Interface	RS-232/Ethernet
Protection Class	III

Mechanical Data

Setting Method	Ethernet
Housing Material	Aluminum
Degree of Protection	IP67
Connection	M12 ? 1, 12-pin
Type of Connection Ethernet	M12 ? 1, 8-pin, X-cod.

Safety-relevant Data

MTTFd (EN ISO 13849-1)

230,41 a

General Data

Web server

yes

Function

1D and 2D code reading

yes

Output

Configurable as PNP/NPN/Push-Pull	yes
Switchable to NC/NO	yes
Illumination Output	yes
RS-232 Interface	yes
Ethernet	yes
PROFINET	yes
EtherNet/IP™	yes

Display brightness may decrease with age. This does not result in any impairment of the sensor function.* -25° C: Ambient conditions should not result in condensation, avoid the formation of ice on the front panel!55° C: Continuous illumination at max. 1% or flash mode at 100% brightness with an exposure time of ? 5 ms, may affect the service life of the product.