| General specifications |
| Sensing range | 80 ... 2000 mm |
| Adjustment range | 120 ... 2000 mm |
| Dead band | 0 ... 80 mm |
| Standard target plate | 100 mm x 100 mm |
| Transducer frequency | approx. 175 kHz |
| Response delay | 65 ms minimum
195 ms factory setting |
| Indicators/operating means |
| LED green | solid: Power-on
flashing: Standby mode or program function object detected |
| LED yellow 1 | solid: object in evaluation range
flashing: program function |
| LED yellow 2 | solid: object in detection range
flashing: program function |
| LED red | solid: temperature/program plug not connected
flashing: fault or program function object not detected |
| Temperature/TEACH-IN connector | Temperature compensation , Evaluation range programming , output function setting |
| Electrical specifications |
| Operating voltage | 10 ... 30 V DC , ripple 10 %SS |
| Power consumption | &le, 900 mW |
| Time delay before availability | &le, 500 ms |
| Interface |
| Interface type | RS 232, 9600 Bit/s , no parity, 8 data bits, 1 stop bit |
| Input/Output |
| Synchronization | bi-directional
0 level -UB...+1 V
1 level: +4 V...+UB
input impedance: > 12 KOhm
synchronization pulse: &ge, 100 µ,s, synchronization interpulse period: &ge, 2 ms |
| Synchronization frequency | |
| Common mode operation | max. 30 Hz |
| Multiplex operation | &le, 30 Hz / n , n = number of sensors , n &le, 5
|
| Output |
| Output type | 1 current output 4 ... 20 mA
1 voltage output 0 ... 10 V |
| Resolution | evaluation range [mm]/4000, but &ge, 0.35 mm |
| Deviation of the characteristic curve | &le, 0.2 % of full-scale value |
| Repeat accuracy | &le, 0.1 % of full-scale value |
| Load impedance | current output: &le, 500 Ohm
voltage output: &ge, 1000 Ohm |
| Temperature influence | &le, 2 % from full-scale value (with temperature compensation)
&le, 0.2 %/K (without temperature compensation) |
| Compliance with standards and directives |
| Standard conformity | |
| Standards | EN 60947-5-2:2007+A1:2012
IEC 60947-5-2:2007 + A1:2012
EN 60947-5-7:2003
IEC 60947-5-7:2003 |
| Approvals and certificates |
| UL approval | cULus Listed, General Purpose |
| CSA approval | cCSAus Listed, General Purpose |
| CCC approval | CCC approval / marking not required for products rated &le,36 V |
| Ambient conditions |
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
| Mechanical specifications |
| Connection type | Connector plug M12 x 1 , 5-pin |
| Degree of protection | IP65 |
| Material | |
| Housing | stainless steel (1.4305 / AISI 303)
PBT plastic parts |
| Transducer | epoxy resin/hollow glass sphere mixture, polyurethane foam |
| Mass | 210 g |
| Factory settings |
| Output | evaluation limit A1: 200 mm
evaluation limit A2: 2000 mm
rising ramp |
