Manufacturer
AirCom Pneumatic
Part number
P822-50_01
Country
Germany
Sale of any product from the AirCom Pneumatic catalog at competitive prices
2technologie will help you choose and buy products and spare parts from AirCom Pneumatic (official website: www.aircom.net). We sell only certified goods and give an official guarantee from the manufacturer AirCom Pneumatic
Motorised proportional flow valve with low power consumption
and resistance to contamination. Throttle setting by wear-
resistant control drives made of oxide ceramic. Throttling occurs
with drip-tight zero shut-off but no gas tightness.
Media: compressed air, vacuum or liquids up to viscosity of 40 mm²/s
Hysteresis: ± 4%
Operation:
DC, synchronous or stepping motor with standard voltage of 24 V DC
or AC ±10% residual ripple and IP 54.
All motors fulfil standards EN50.081-1, EN50.082-2 and 89/336/EEC.
DC_motor_(15/24):
Motor with feedback potentiometer for servo-amplifier.
Resistor 1kΩ ± 20 %, control e.g. by servo-amplifier.
Only part of potentiometer range is used.
Voltage for potentiometer 12 V, max. 10 mA.
DC_motor_(50/51):
With integrated position controller.
Setpoint input using jumpers = 0...10 V, 0/4...20 mA.
Input resistance 200 kΩ at voltage signal, 500 Ω at current signal.
Stepper_motor_(38):
Bipolar, by means of SAA1042A (Motorola) with drop resistance of
44 Ω per phase at a driver (full-step).
operating voltage of 24 V ± 5%. 2028 steps for 90° control disc turn,
200 Hz nominal step frequency.
Temperature_range: 10 °C to 90 °C / 14 °F to 194 °F
Protection_class: IP 54
Body: brass
Control_discs: oxide ceramic
Elastomer: NBR/Buna-N, optionally FKM or EPDM
and resistance to contamination. Throttle setting by wear-
resistant control drives made of oxide ceramic. Throttling occurs
with drip-tight zero shut-off but no gas tightness.
Media: compressed air, vacuum or liquids up to viscosity of 40 mm²/s
Hysteresis: ± 4%
Operation:
DC, synchronous or stepping motor with standard voltage of 24 V DC
or AC ±10% residual ripple and IP 54.
All motors fulfil standards EN50.081-1, EN50.082-2 and 89/336/EEC.
DC_motor_(15/24):
Motor with feedback potentiometer for servo-amplifier.
Resistor 1kΩ ± 20 %, control e.g. by servo-amplifier.
Only part of potentiometer range is used.
Voltage for potentiometer 12 V, max. 10 mA.
DC_motor_(50/51):
With integrated position controller.
Setpoint input using jumpers = 0...10 V, 0/4...20 mA.
Input resistance 200 kΩ at voltage signal, 500 Ω at current signal.
Stepper_motor_(38):
Bipolar, by means of SAA1042A (Motorola) with drop resistance of
44 Ω per phase at a driver (full-step).
operating voltage of 24 V ± 5%. 2028 steps for 90° control disc turn,
200 Hz nominal step frequency.
Temperature_range: 10 °C to 90 °C / 14 °F to 194 °F
Protection_class: IP 54
Body: brass
Control_discs: oxide ceramic
Elastomer: NBR/Buna-N, optionally FKM or EPDM
